HomeCamera :: Support :: DLink Support

Download the HomeCamera firmware for your DCS-2120 camera

The firmware on this page will help you to HomeCamera-enable your D-Link DCS-2120 camera.

If you purchased your camera with the HomeCamera enhancements pre-installed, you do NOT need this firmware - it’s already installed in your camera. Instead, please click here to learn how to setup your camera for the HomeCamera service.

Cautionary Notes and Disclaimer:

This firmware will not work on any other camera apart from the Dlink DCS 2120. Attempting to install this firmware on any other camera might cause your camera to malfunction or become entirely unusable.

Please ensure your camera is connected via a physical network wire into your network before you attempt to update the firmware - if you attempt to update your firmware when your camera is connected via wireless, you might irrecoverably damage your camera. Please ensure you read and thoroughly familiarize yourself with the firmware update process as documented in your camera manual.

As with any consumer firmware upgrade, you understand and accept that Wireless Intellect Labs will not be liable for damages, whether direct or consequential, caused due to malfunctioning of the firmware or the device, even if we may have been advised of the possibility of such occurrence. (That said, we’ve flash-upgraded many many cameras and haven’t had any problems…)

Download the installation wizard which will help you to install the firmware AND will help you to setup your DCS2120 for HomeCamera.
Download the firmware.
Download the Quick Installation Guide and Manual
Follow the step-by-step guide to install the firmware and setup your camera

Back